Collectd

Supported event types: logs

The Collectd input plugin lets you receive datagrams from the collectd service over UDP. The plugin listens for collectd network protocol packets and converts them into Fluent Bit records.

Configuration parameters

The plugin supports the following configuration parameters:

Key	Description	Default
listen	Set the address to listen to.	0.0.0.0
port	Set the port to listen to.	25826
threaded	Indicates whether to run this input in its own thread.	false
typesdb	Set the data specification file. You can specify multiple files separated by commas. Later entries take precedence over earlier ones.	/usr/share/collectd/types.db

Get started

To receive collectd datagrams, you can run the plugin from the command line or through the configuration file.

Command line

From the command line you can let Fluent Bit listen for collectd datagrams with the following options:

fluent-bit -i collectd -o stdout

By default, the service listens on all interfaces (0.0.0.0) using UDP port 25826. You can change this directly:

fluent-bit -i collectd -p listen=192.168.3.2 -p port=9090 -o stdout

In this example, collectd datagrams will only arrive through the network interface at 192.168.3.2 address and UDP port 9090.

Configuration file

In your main configuration file append the following:

fluent-bit.yaml

pipeline:
  inputs:
    - name: collectd
      listen: 0.0.0.0
      port: 25826
      typesdb: '/usr/share/collectd/types.db,/etc/collectd/custom.db'

  outputs:
    - name: stdout
      match: '*'

fluent-bit.conf

[INPUT]
  Name         collectd
  Listen       0.0.0.0
  Port         25826
  TypesDB      /usr/share/collectd/types.db,/etc/collectd/custom.db

[OUTPUT]
  Name   stdout
  Match  *

With this configuration, Fluent Bit listens to 0.0.0.0:25826, and outputs incoming datagram packets to stdout.

typesdb configuration

You must set the same types.db files that your collectd server uses. Otherwise, Fluent Bit might not be able to interpret the payload properly.

The typesdb parameter supports multiple files separated by commas. When multiple files are specified, later entries take precedence over earlier ones if there are duplicate type definitions. This lets you override default types with custom definitions.

For example:

typesdb: '/usr/share/collectd/types.db,/etc/collectd/custom.db'

In this configuration, custom type definitions in /etc/collectd/custom.db override any matching definitions from /usr/share/collectd/types.db.