The udp input plugin allows to retrieve structured JSON or raw messages over a UDP network interface (UDP port).
The plugin supports the following configuration parameters:
| Key | Description | Default |
|---|---|---|
In order to receive JSON messages over UDP, you can run the plugin from the command line or through the configuration file:
From the command line you can let Fluent Bit listen for JSON messages with the following options:
By default the service will listen an all interfaces (0.0.0.0) through UDP port 5170, optionally you can change this directly, e.g:
In the example the JSON messages will only arrive through network interface under 192.168.3.2 address and UDP Port 9090.
In your main configuration file append the following Input & Output sections:
Once Fluent Bit is running, you can send some messages using the netcat:
In Fluent Bit we should see the following output:
When receiving payloads in JSON format, there are high performance penalties. Parsing JSON is a very expensive task so you could expect your CPU usage increase under high load environments.
To get faster data ingestion, consider to use the option Format none to avoid JSON parsing if not needed.
Listen
Listener network interface.
0.0.0.0
Port
UDP port where listening for connections
5170
Buffer_Size
Specify the maximum buffer size in KB to receive a JSON message. If not set, the default size will be the value of Chunk_Size.
Chunk_Size
By default the buffer to store the incoming JSON messages, do not allocate the maximum memory allowed, instead it allocate memory when is required. The rounds of allocations are set by Chunk_Size in KB. If not set, Chunk_Size is equal to 32 (32KB).
32
Format
Specify the expected payload format. It support the options json and none. When using json, it expects JSON maps, when is set to none, it will split every record using the defined Separator (option below).
json
Separator
When the expected Format is set to none, Fluent Bit needs a separator string to split the records. By default it uses the breakline character (LF or 0x10).
Source_Address_Key
Specify the key where the source address will be injected.