Disk I/O Metrics

The disk input plugin, gathers the information about the disk throughput of the running system every certain interval of time and reports them.

Configuration Parameters

The plugin supports the following configuration parameters:

Key

Description

Interval_Sec

Polling interval (seconds). default: 1

Interval_NSec

Polling interval (nanosecond). default: 0

Dev_Name

Device name to limit the target. (e.g. sda). If not set, in_disk gathers information from all of disks and partitions.

Getting Started

In order to get disk usage from your system, you can run the plugin from the command line or through the configuration file:

Command Line

$ fluent-bit -i disk -o stdout
Fluent Bit v1.x.x
* Copyright (C) 2019-2020 The Fluent Bit Authors
* Copyright (C) 2015-2018 Treasure Data
* Fluent Bit is a CNCF sub-project under the umbrella of Fluentd
* https://fluentbit.io

[2017/01/28 16:58:16] [ info] [engine] started
[0] disk.0: [1485590297, {"read_size"=>0, "write_size"=>0}]
[1] disk.0: [1485590298, {"read_size"=>0, "write_size"=>0}]
[2] disk.0: [1485590299, {"read_size"=>0, "write_size"=>0}]
[3] disk.0: [1485590300, {"read_size"=>0, "write_size"=>11997184}]

Configuration File

In your main configuration file append the following Input & Output sections:

[INPUT]
    Name          disk
    Tag           disk
    Interval_Sec  1
    Interval_NSec 0
[OUTPUT]
    Name   stdout
    Match  *

Note: Total interval (sec) = Interval_Sec + (Interval_Nsec / 1000000000).

e.g. 1.5s = 1s + 500000000ns

Last updated